TRANSFORMER 4 cpu cooler
Published 2010-12-06
(01) FAN x2
(02) ā€œIā€ shaped bracket x1
(03) Fan clip x4
(04) All in one backplate x1
(05) 1366 Backplate x1
(06) Washer x8
(07) Nut x4
(08) Blot x4
(09) Screw x4
(10) Thermal Paste x1
Additional remarks
Intel LGA2011
STEP 1
Screw the screw on the nuts of motherboard.
STEP 2
Evenly spread the thermal grease on the CPU surface.
STEP 3
Put the I-shaped clip in the groove of the heat sink,and then place the heat sink on CPU.(Recommendation:First dismantle the fan for convenient installation.
STEP 4
Screw up the nuts diagonally and tighten them twice.
STEP 5
Install the fan onto the heat sink.
STEP 6
DConnect the socket of the Y-shaped cable to the CPU,and plug the fan connector into the Y cable.
STEP 7
Finish the installation.
Intel-Pentium D / P4 (LGA775) / LGA1366 / LGA1156 / LGA1155
STEP 1
Put the screws through the back plate.
STEP 2
Place the insulating cushion on the motherboard to prevent short circuit.
STEP 3
Put the screws diagonally.
STEP 4
Evenly spread the thermal paste on the CPU surface.
STEP 5
Put the I-shaped clip in the groove of the heat sink,and then place the heat sink on CPU. (Recommendation:First dismantle the fan for convenient installation.)
STEP 6
Screw up the nuts diagonally and tighten them twice.
STEP 7
Install the fan onto the heat sink.
STEP 8
Connect the socket of the Y-shaped cable to the CPU,and plug the fan connector into the Y cable.
STEP 9
Finish the installation.
For AMD-Athelon 64 / Opteron (Socket 754 / 939 / 940 / AM2 / AM2 + / AM3)
STEP 1
Dismantle the original plastic bracket of AMD.
STEP 2
Put the screws through the back plate.
STEP 3
Place the insulating cushion on the motherboard to prevent short circuit.
STEP 4
Put the screws diagonally.
STEP 5
Evenly spread the thermal grease on the CPU surface.
STEP 6
Screw the AMD bracket on the I shape clip.
STEP 7
Put the I-shaped clip in the groove of the heat sink,and then place the heat sink on CPU. (Recommendation:First dismantle the fan for convenient installation.)
STEP 8
Screw up the nuts diagonally and tighten them twice.
STEP 9
Install the fan onto the heat sink.
STEP 10
Connect the socket of the Y-shaped cable to the CPU, and plug the fan connector into the Y cable.
STEP 11
Finish the installation.
COPYRIGHT EVERCOOL THERMAL CO.,LTD. 2013. ALL RIGHTS RESERVED